Purpose: To compare shear bond strengths of three different self-etching adhesive systems of different pH values to enamel bleached with carbamide peroxide, treated with casein phosphopeptide-amorphous calcium phosphate (CPP-ACP), or treated with CPP-ACP subsequent to bleaching with carbamide peroxide. Materials and Methods: Thirty-six human third molars were cut into 4 sections and randomly assigned to 4 groups (n = 36): group I: no treatment; group II: bleaching; group III: CPP-ACP; group IV: bleaching and CPP-ACP. After surface treatments, the samples of each group were further divided into three subgroups (n = 12) based on the adhesive used. The adhesives Clearfil SE Bond (CSE), AdhesE (ADE), and Adper SE Plus (ADP) were applied, and resin composite cylinders with a diameter of 2 mm and a height of 4 mm were bonded to the enamel. Then the specimens were subjected to shear bond strength testing. Two-way ANOVA and a post-hoc Tukey's test were used for statistical analysis (α = 0.05). Results: There were significant differences between the adhesive systems (p 0.001) and surface treatments (p 0.001), but no significant interactions were observed between these variables (p = 0.78). The CSE adhesive system showed the highest bond strength, and the bleaching procedure reduced bond strengths (p = 0.001). Furthermore, there were no significant differences in shear bond strength values between the control and CPP groups. However, the differences between other groups were statistically significant (p 0.05). Conclusion: Bleaching reduced shear bond strength to enamel, but CPP-ACP application did not affect the bond strength to intact and previously bleached enamel. The bond strength of adhesives with different pH values to enamel was material dependant. Schlagwörter: pH, self-etching adhesives, bleaching, casein phosphopeptide-amorphous calcium phosphate, bond strength