Aim: The aim of this in vitro study was to investigate the influence of scan paths on the accuracy (trueness and precision) of intra-oral scanning of an implant impression on an edentulous patient.
Material and methods: An epoxy resin maxillary model was made with 6 bone level implants (NobelParallel Conical Connection RP, NobelBiocare®). The implants were placed at the spot of the first incisor, the canine and the first molar. The trans gingival component (Multi-unit, NobelBiocare®) was screwed onto the implants. The scanbodies (IO 2C-A, Elos Accurate®) were then screwed onto the multi-units. The model was run through a coordinate measurement machine to obtain a control cast. Then, five different scanning paths, respectively the zigzag technique (ZZT), the zigzag technique with palatal (ZZTP), the wrap technique (WT), the wrap technique with palatal (WTP), and the big zigzag technique (BZZT), were applied by a single operator. Finally, each scan was compared to the control model. Results were assessed by one-way ANOVA and linear mixed effects models at P<0.05.
Results: The study showed that scan paths ZZT and ZZTP had significantly lower absolute positioning errors and residual mean square errors than the others (P<0.0001). For distances between consecutive implant axes and for absolute vertical errors, their superiority was borderline (P<0.10). Overall, techniques ZZT and ZZTP were equally performant and proved to be the most accurate.
Conclusions: This in vitro experimental study demonstrates that the scan path can have an influence on the accuracy of the optical impression for full arch rehabilitation on implants.