The Journal of Adhesive Dentistry, Volume 27/2025

Objective: To evaluate the effect of pre-procedural antiseptic mouthwashes on dentin bond strength of different adhesive systems. Methods: Flat occlusal dentin surfaces from 120 extracted human molars were randomly divided into four groups according to mouthwashes (0.12% chlorhexidine = CHX, 1% hydrogen peroxide = HP, 0.2% povidone-iodine = PI, and no mouthwash/control) and three subgroups of adhesives used (Clearfil SE Bond; CSE, Single Bond Universal = SBU in etch-and-rinse (ER) or self-etch (SE) modes) (n = 8). Composite resin was built up, and all bonded teeth were stored in 37°C distilled water for 24 h. Stick-shaped specimens were prepared and subjected to microtensile bond strength (µTBS) test. Failure mode analysis was determined using a light microscope. A resin-dentin interface was observed using scanning electron microscopy (SEM, n = 2). Elemental analysis in the PI group was further examined by SEM with energy-dispersive X-ray spectroscopy. The µTBS data were statistically analyzed by two-way analysis of variance (ANOVA) and Duncan’s multiple comparison (P < 0.05). Results: Rinsing with PI followed by SBU-SE demonstrated significantly higher µTBS than the control group (P < 0.05). Rinsing with HP showed significantly lower bond strength for CSE (P < 0.05). However, the effect of adhesive systems was not observed for all mouthwashes used (P > 0.05). SEM/EDX revealed the iodine deposition in the underlying dentin, where the highest amount of iodine was found for SBU-SE. Conclusion: CHX and PI can be recommended as pre-procedural antiseptic mouthwashes since they show no negative impact on µTBS for all tested adhesives. The dentin bond strength of CSE is hampered in the HP mouthwash group, and this should be a concern for the use of self-etching adhesive afterward. Parole chiave: adhesion to dentin, adhesive, dentin, microtensile bond strength, pre-procedural antiseptic mouthwash

Purpose: The aim of this study was to evaluate the marginal quality and wear of bulk-fill composite resins (BFs) for Class-II restorations of primary and permanent molars in comparison to a conventionally layered composite resin (RC) and to compare the results of the two dentitions. Materials and Methods: Eighty (40 primary and 40 permanent) extracted molars received standardized Class-II cavity preparations and were restored with either one of two flowable BFs, one of two high viscous BFs, or a composite resin (RC). Thermomechanical loading (TML; 2,500 cycles +5°C/+55°C; 100,000 cycles, 50N, 1.67Hz) followed. A quantitative marginal analysis using SEM images and a profilometric quantification of two-body wear were carried out using replicas. ANOVA, Kruskal–Wallis, Mann–Whitney U, and Wilcoxon signed-rank tests were used for statistical analysis (P < 0.05). Results: For both dentitions, a significant reduction of perfect margins was observed after TML (P < 0.02). For the primary dentition, the flowable BFs showed significantly less perfect margins than all high viscous materials (P < 0.005). For the permanent dentition, RC showed significantly fewer gaps than the flowable BFs (P < 0.04). Regarding wear, within the dentitions, no significant differences could be computed between groups with regard to the maximum height loss (P < 0.05). Conclusion: All of the investigated bulk-fill composite resins showed satisfactory in-vitro results for both tested parameters in primary and permanent teeth, with a superiority of the high-viscosity materials in terms of marginal quality. Parole chiave: bulk-fill composite resins, marginal quality, permanent teeth, primary teeth, restoration materials, wear