DOI: 10.3290/j.jad.a19820, PubMed ID (PMID): 21246067Pages 473-480, Language: EnglishMiragaya, Luciana / Maia, Luciane Cople / Sabrosa, Carlos Eduardo / De Goes, Mário Fernando / Da Silva, Eduardo MoreiraPurpose: To evaluate the influence of four surface treatments on the bond strength of a self-adhesive resin cement to an yttria-stabilized zirconia (Y-TZP) ceramic material (Lava Frame zirconia).
Materials and Methods: Forty plates (8 x 6 x 1 mm) of a Y-TZP ceramic restorative material were randomly assigned to four groups (n = 10) according to the surface treatments: control, no treatment; airborne-particle abrasion with 50-µm Al2O3; coating with an MDP-based primer; conditioning with Rocatec System. The ceramic plates treated with each of the four methods were further divided into 2 subgroups according to the resin cement tested: RelyXTM ARC (ARC, conventional) and RelyXTM Unicem (Ucem, self-adhesive). The resin cements were put into PVC tubes (diameter 0.75 mm, 0.5 mm height) placed on the ceramic plate surfaces. After water storage at 37°C for 24 h, the specimens were submitted to a microshear bond strength (µSBS) test at a crosshead speed of 1.0 mm/min.
Results: The surface treatments significantly influenced the µSBS (p 0.05). For the four surface treatments, UCem presented significantly higher µSBS than ARC (p 0.05). For both resin cements, the best result was produced by the MDP-based primer: ARC 15.9 ± 5.0 MPa and UCem 36.2 ± 2.1 MPa. The highest µSBS values were presented by UCem on ceramic plates treated with the MDP-based primer (36.2 ± 2.1 MPa) and Rocatec system (37.4 ± 2.3 MPa).
Conclusion: Irrespective of the surface treatment, the self-adhesive resin cement performed better in terms of bond strength to yttria-stabilized zirconia ceramic than did conventional resin cement.
Keywords: yttria-stabilized zirconia ceramic, microshear bond strength, surface treatment, resin cements, SEM, EDS