Objectives: To obtain a natural emergence profile and optical characterictics in anterior implant supported crowns by fabricating individually designed and digitally fabricated lithium-disilicate abutment crowns without the need of intra-oral cementation procedures. Materials and Methods: One-stage surgery with a bone level implant (Camlog; diameter: 3.8 mm and height: 11 mm) was conducted on a patient with a maxillary left lateral incisor congenital absence. After a healing period of 16 weeks, a titanium base (Camlog Titanium base CAD/CAM) was placed on the implant and a digital impression was obtained (Cerec Bluecam AC, Sirona). Due to the appropriate vestibulo-palatal position of the implant, screw hole of the abutment could be positioned on the palatal surface of the crown. Therefore, a single piece abutment crown was designed and manufactured from a lithium-disilicate CAD/CAM block (e.max CAD abutment solutions, A16, MO, Ivoclar Vivadent) (Cerec MCXL, Sirona). Following the crystallization procedures, the ceramic part was stained, glazed and luted on the titanium base using an opaque self-cure resin cement (Multilink hybrid abutment cement, Ivoclar Vivadent). The margin line was mechanically polished and the abutment crown was placed and torqued with 35Ncm. The patient was followed-up for gingival contour and papillae formation for 36 months without any complaints. Conclusion: Screw-retained monolithic abutment crown revealed successful gingival contour and health together with optimum estethic optical properties. Schlagwörter: lithium-disilicate, CAD/CAM, screw-retained crown