The reconstruction of alveolar ridge defects can be challenging, especially when the lesion is large, noncontained, and located in the esthetic region. The present report describes the guided bone regeneration (GBR) procedure and prosthetic rehabilitation of a severe perforation defect in the anterior maxilla. Clinical and radiographic evaluations of the lesion indicated an endodonticperiodontal origin, and biopsy results confirmed the absence of malignancy. GBR was performed with the use of cortical mineralized freeze-dried bone allograft (FDBA) combined with recombinant human platelet-derived growth factor-BB (rhPDGF-BB) and a resorbable collagen membrane without the use of tenting or fixation screws. Six months after GBR, CBCT revealed adequate bone fill for the placement of 4.1 × 10–mm or 4.1 × 12–mm dental implants. The implant surgery was fully guided with a two-stage approach. After 10 months of healing, the implants were loaded with a screw-retained porcelain partial denture. The staged GBR approach, using a combination of FDBA, rhPDGF-BB, and a resorbable membrane without the use of tenting or fixation screws, resulted in significant bone fill, successful implant placement, and a functional and esthetic implant-supported prosthesis. Schlagwörter: Alveolar Bone Loss, Bone Regeneration, Dental Implant, Case Report

An advantage of treated implant surfaces is their increased degree of hydrophilicity and wettability compared with untreated, machined, smooth surfaces that are hydrophobic. The present preclinical in vivo study aimed to compare the two implant surface types, namely SLActive (Straumann, Basel, Switzerland) and nanohydroxyapatite (Hiossen, Englewood Cliffs, NJ, USA), in achieving early osseointegration. The authors hypothesised that the nanohydroxyapatite surface is comparable to SLActive for early bone–implant contact. Six male mixed foxhounds underwent mandibular premolar and first molar extraction, and the sockets healed for 42 days. The mandibles were randomised to receive implants with either SLActive (control group) or nanohydroxyapatite surfaces (test group). A total of 36 implants were placed in 6 animals, and they were sacrificed at 2 weeks (2 animals), 4 weeks (2 animals) and 6 weeks (2 animals) after implant surgery. When radiographic analysis was performed, the difference in bone level between the two groups was statistically significant at 4 weeks (P = 0.024) and 6 weeks (P = 0.008), indicating that the crestal bone level was better maintained for the test group versus the control group. The bone–implant contact was also higher for the test group at 2 (P = 0.012) and 4 weeks (P = 0.011), indicating early osseointegration. In conclusion, this study underscored the potential of implants with nanohydroxyapatite surfaces to achieve early osseointegration. Schlagwörter: acid-etched surface, bone–implant contact, dental implant, histology, histomorphometric analysis, nanohydroxyapatite, osseointegration, radiographs, SLActive, tooth extractions This research was funded by Hiossen, Englewood Cliffs, NJ, USA. The funders played no role in the collection, analysis or interpretation of data, in the writing of the manuscript or in the decision to publish the results. The authors declare there are no conflicts of interest relating to this study.

Objective: The predictability and long-term success of periodontal regeneration begins with oral hygiene education, disease management, and an individually tailored periodontal maintenance protocol. The treatment outcomes could be enhanced when biologics and bone grafts are combined. The aim of this report was to describe the outcome of two complex infrabony defects in the same patient treated with recombinant human platelet-derived growth factor-BB (rhPDGF-BB) and freeze-dried bone allograft (FDBA) over 10 years. Case presentation: Two complex infrabony defects were treated following guided tissue regeneration principles and procedures. Full-thickness flaps were raised to allow visualization of the defects. The areas were debrided, and exposed root surfaces were planed. FDBA and rhPDGF-BB were combined to fill both defects. A collagen membrane was used over the bone graft in one case. The flaps were reapproximated to achieve primary closure. The patient was seen for regular periodontal maintenance visits and clinical and radiographic follow-ups over 10 years. Throughout the examination periods, the probing depths improved without bleeding on probing, and there was radiographic evidence of bone regeneration. Conclusion: The growth factor-infused bone graft was successfully utilized for periodontal regeneration in complex bony defects. Schlagwörter: bone graft, case report, collagen membrane, growth factor, periodontal disease, periodontal regeneration

This investigation was designed to evaluate crestal bone stability and soft tissue maintenance to Laser-Lok tapered tissue-level implants. Twelve patients presenting with an edentulous site adequate for the placement of two implants were recruited from four dental offices (2 to 4 patients per office). Each patient received two Laser-Lok tissue-level implants placed with a 3-mm interimplant distance according to a surgical stent. The implants were placed so that the Laser-Lok zone sat at the junction between hard and soft tissues. A total of 24 implants were placed, and all achieved satisfactory crestal bone stability and soft tissue maintenance 1 year after receiving the final prosthetic restoration.

This ex vivo study evaluates the incidence of sinus membrane perforation during implant site osteotomy with two different types of drills and drilling techniques. Fifty goat heads with 50 sinus pairs (100 sinus sides) were assigned to two groups (osseodensification bur [OB] group and inverse conical shape bur [ICSB] group) to simulate transcrestal sinus elevation (50 sinus sides per group). An osteotomy was performed to pass through the lateral sinus wall no more than 3 mm. The integrity of the sinus membranes was examined and confirmed under a microscope. Of the 50 sinuses per group, the OB group presented with 14 (28%) perforated sinuses, while the ICSB group presented with 2 (4%) perforated sinuses. Of the 14 perforations from the OB group, 6 (42.9%) showed a pinpoint perforation pattern, 4 (28.5%) of which were not visible until direct air pressure was applied. Overall, the ICSB drill group demonstrated a lower sinus perforation rate than the OB group.

The present study aimed to evaluate the osseoconduction ability of an airborne particle-abraded and etched (SAE) titanium alloy surface when placed in humans with poor bone quality. Four patients scheduled to receive an implant-supported full-arch prosthesis received two additional reduced-diameter implants to be harvested after 6 months of submerged healing. Undecalcified vestibulopalatal/vestibulolingual histologic sections were prepared after the micro-computerized tomography (μCT) examination. Six implant sides from four biopsied implants displayed a type IV bone environment and were included in the present study. Bone-to-implant contact (BIC) was first measured on each implant side. The estimated initial BIC (E-iBIC) was evaluated by superimposing the implant profile 0.25 mm away from its actual position. The μCT provided information about the local and adjacent bony architecture. The mean BIC was 62.5% ± 10.6%, while the mean E-iBIC was 33.1% ± 4.4%. The E-iBIC/BIC ratio was 1.81 ± 0.38. The 3D μCT sections showed the thin bone trabeculae covering the implant surface; although they seemed to be separated from the rest of the bony scaffold, they were much more interconnected than what appeared to be on the 2D histologic preparations. This limited number of human histologic samples document, for the first time, that the SAE titanium alloy implant surface is apparently osseoconductive when placed in poor human bone quality. The average BIC was 1.81 times higher than the E-iBIC. This high osseoconductivity may explain the predictable clinical behavior of implants with this type of SAE textured surface in type IV bone.

The goal of this multicenter randomized controlled study was to evaluate the effectiveness of a newly developed ionic-sonic electric toothbrush in terms of plaque removal and reduction of gingival inflammation. A total of 78 subjects from three dental centers were invited to join the study. They were randomized to receive either a manual toothbrush (control group) or an ionic-sonic electric brush (test group). Full-mouth prophylaxis and oral hygiene instructions based on the stationary bristle technique were provided 1 week prior to the baseline visit. At baseline and at each follow-up appointment, Plaque Index (PI) and Gingival Index (GI) were recorded. In addition, probing depth (PD) and bleeding on probing were recorded at baseline and at the last appointment (week 5). At completion of the study, subjects in the test group were given a questionnaire regarding their satisfaction with the toothbrush. Sixty-four subjects completed the study (control: 28; test: 36). The mean age of the subjects was 36.90 ± 12.19 years. No significant difference between the baseline and 5-week PD was found. Plaque removal efficacy and reduction in gingival inflammation were more significant for the test group at week 2. Both the control and test groups showed statistically significant improvement in PI and GI from baseline to week 5. The ionic-sonic toothbrush was more effective than manual toothbrush after a 1-week application.

This investigation was designed to evaluate the reestablishment of bone-toimplant contact on infected dental implant surfaces following decontamination with an erbium, chromium:yttrium-scandium-gallium-garnet (Er,Cr:YSGG) laser and reconstructive therapy. Three patients presenting with at least one failing implant each were enrolled and consented to treatment with the Er,Cr:YSGG laser surface decontamination and reconstruction with a bone replacement allograft and a collagen membrane. The laser treatment was carried out at a setting of 1.5 W, air/water of 40%/50%, and pulse rate of 30 Hz. At 6 months, all three patients returned for the study. En bloc biopsy samples of four implants were obtained and analyzed. Two patients had excellent clinical outcomes, while one patient with two adjacent failing implants experienced an early implant exposure during the follow-up period. There was histologic evidence of new bone formation with two implant specimens and less bone gain with the others. Despite the small sample size, these were optimistic findings that suggested a positive role of Er,Cr:YSGG laser in debridement of a titanium implant surface to facilitate subsequent regenerative treatment. This investigation provides histologic evidence as well as encouraging clinical results that use of the Er,Cr:YSGG laser can be beneficial for treatment of peri-implantitis, but further long-term clinical studies are needed to investigate the treatment outcome obtained.

The goal of the present study was to evaluate human histologic healing of dental implants with a unique triangular neck design that is narrower than the implant body. Four patients in need of full-mouth reconstruction were recruited and received several implants to support a full-arch prosthesis. In each patient, two additional customized reduced-diameter implants were placed, designated to be harvested after 6 months of submerged healing. The eight harvested implants were all placed in healed edentulous maxillary or mandibular ridges. These implants were Ø 3.5 × 8 mm in size, and the final osteotomy drill allowed for the creation of a gap up to 0.2 mm in size between the coronal aspect of the triangular implant neck and the surrounding bone. At the end of the healing period, the implants were retrieved with the surrounding bone. Microcomputed tomography (μCT) was performed before processing the biopsy samples for undecalcified histologic exampination. Bone-to-implant contact (BIC) was measured from the μCT data and from buccolingual/buccopalatal and mesiodistal central histologic sections. All implant gaps were filled by mature remodeled bone. The mean BICs of the BL/BP and MD sections were 64.45% ± 6.86% and 65.39% ± 10.44%, respectively, with no statistically significant difference. The mean 360-degree 3D BIC measured all over the implant surface was 68.58% ± 3.76%. The difference between the BIC measured on the μCT and on the histologic sections was not statistically significant. The positive histologic results of the study confirmed the efficacy of this uniquely designed dental implant.

This investigation was designed to evaluate the long-term effectiveness of human placental allograft in root coverage procedures in terms of clinical and esthetic outcomes. Thirteen patients with 28 maxillary or mandibular recession defects > 4 mm deep were reexamined at 6 months and 5 years postoperatively. Overall, mean percentage of root coverage decreased from 65.58% ± 16.45% to 49.75% ± 19.40% with a greater stability of the gingival margin in the mandible. At 5 years, 18 sites maintained at least 2 mm of keratinized tissue. Gingival color and texture blended well with adjacent soft tissue area in 78.6% of treated sites.